Question about Laars Lite2 Ld 400,000 Btu Heater
...code FL0. Try cleaning filter or buy a new one i worked Cal Spas was senior service tec in las vegas never worked on laars with digital read outs but flow is not enough water passing threw exchanger ...
Question about Lite2 Lj175n 175,000 Btu Natural Gas Heater
my header goes on, then after awhile, it shuts off then the code says flo, so what is the problem and how do I fix it and where do I get the parts. clean the filter first
Question about Lite 2 Natural Gas Pilot Light Heater
...flo code indicates the the water pressure switch is open. If you know that you have more than the minimum amount of flow going through the heater, then the problem is a clogged or defective pressure ...
Question about Lite 2 Natural Gas Pilot Light Heater
code is coming up FL 0. I had info on the screen until I put a jumper wire on it and now I am getting nothing on the screen. There is power going to the heater. my e-mail address is [email protected]
Fault Low Flo Pressure I am getting an error code for the Jandy remote "Fault Low REF Pressure check pressure switch and copper tube to it
...code fl0 and will not turn on Flo ? for Flow Error? That would for any number of reasons that the Flow Switch is not sensing enough water flow to trip the sensor/pressure switch or actual true water ...
Question about LAARS LX250 - NATURAL GAS, DIGITAL READ-OUT, LOW NOX
...code AIR FLO SW and sometimes a HI LIM SW cannot locate the source of the problem? I have a LX250N-L. I am getting mostly a AIR FLO SW error, but I have shorted the switch and gotten no answer or ...
Usually answered in minutes!
193 Questions
170 Questions
177 Questions
72 Questions