flexplate replacement can you just slide the trans back to replace flexplate ? yes you can. it will not give you much room . but you can do it good luck you would need to slide it over farther than ...
...and I replaced the starter. The old starter's gear's teeth were worn down so I am assuming the flexplate is bad since I put a new starter in and it still won't start. How do I replace the ...
new starter but sometimes grinds when starting This is caused by damaged gear teeth on the Flywheel/Flexplate, the new starter will be damaged if you don't replace the Flywheel/Flexplate
describe how to fix a flexplate that is rattling and hitting against the starter. I was told it is cheaper to get a motor. Is this true? If not, what will be a quote to get it fix? You have to remove ...
...worse. once per 10 starts. starts on third try. It sounds like the gap between the starter gear and flexplate is growing. The ring gear may be worn out in spots causing the starter not to engage the ...
Question about 1999 Silverado 1500
...tested it. it spins but will not engage. Sometimes the starter will really mess up the teeth on the flexplate/flywheel. Try spinning the flexplate or flywheel a lil to get to some fresh teeth. There ...
and trans,driveshaft,brakes. Truck performs perfect.Sounds horrible. Any clues would help Check the flexplate for cracks.If you see any cracks replace the flexplate
How to remove the flywheel on a Buick rend http://www.carrepairpro.com/2012/03/how-to-replace-flexplate-on-buick.html Solved How to replace Flexplate on Buick Rendezvous
Question about 1999 Silverado 1500
Replaced transmission in 2013 ford escape 1.6 turbo. Flexplate failure. Replaced flexplate and starter. Now starter will not engage flexplate fully to start engine possible incorrect pitch of the ring
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
