Questions & Answers for: flex shaft

flex shaft attachement. Is it normal for the "Flex Shaft" attachment to get hot when in use? I no longer have the owners manual to refer to, to even know if I have it attached correctly! I have used a

...Flex shaft attachment model 225 The spring inside the shaft broke. How can I repair this myself? Thanks, Mary Dremel has an exchange program for the 225 Flex Shaft. Send your flex shaft and 17.90 and ...

...wear on the flex shaft.   white lithium grease works well get it in a spray can and spray it in the tube where the flex shaft goes and then coat the flex shaft and ...

...flex shaft attachment. Did not need to use the flex shaft until recently. When I took it out of the box for the first time, there was no cable inside the shaft. When contacted Worksmith said that it ...

flex shaft attachment how does one attach the multipro flex shaft to the 395 dremel tool? Takes an adapter to screw onto the nose of the Dremel. The shaft itself is gripped by the correct size collet ...

...flex- shaft.Remove the LOWER from the upper shaft, and while turning the string head, see if the top end of the flex shaft turns also. I think your unit has a clutch which makes diagnosing the flex ...

...quit turning was working fine then blade quit turning remove and inspect blade for damage. if all is well check flex shaft conection, may have damaged the inner flex shaft or the ends to the flex ...

...that applies pressure to the flex shaft maybe it has gone bad, sometimes the shaft housing slips away from motor enough that flex shaft will not reach the head and the flex shaft could have

...how to starter motor turn flex shaft is tight on motor shaft turns as far as I can see but don't engage the flywheel or turn at flywheel end try lubricating it. flex shaft and starter motor ...

...flex shaft 225-01 You screw off the collar on the tool, remove the chuck and inner part. The chuck is replaced with a special chuck (no inner piece). The special chuck has a square opening in it's ...