92 s10 4.3 auto the flex plate ontransmission keeps working the bolts loose u tried putting teflon tape on the bolt? what about locktight?
...filters have just the one standard opening for lines going in. sounds like your truck has the flex fuel engine. engine code 5. a flex fuel filter has the additional lines like you say your
2001 2.2l flex fuel my truck will start but will not run i have a 2001 2.2l flex my truck strated actin funny the other by spittin and sputterin would run but now power and no obd2 light , i took it ...
...fuel rail. dismantaling the head from the block. I need to know how to disconnect the fuel line at flex line to steel line leading to the fuel rail need to buy disconnect tool that slides around
...the part that connects to the manifold? donut gasket. or flange depends on the setup. it may have a flex pipe my 2000 s10 had a exhaust leak an thats what it ...
MY TRUCK IS A 2000 S-10 2.2SF1 AND MY O2 SENSOR FOR FUEL FLEX IS NOT WORKING. MY Q IS HOW MAY O2 DOES IT HAVE AND WHERE ARE THEY LOCATED Has two, one after the cylinder head, and the other after the ...
where is the crank sensor on 2000 s-10 2.2 litre THERES A MAGNET ON THE FLEX PLATE(FLYWHEEL) AND A SENSOR JUST IN FRONT (LOOKS LIKE A SMALL SPARKPLUG WITH A PIGTAIL) MAY BE MOUNTED INSIDE THE TIMING ...
...box. Unfortunately, it was a poor design where the solder points are susceptible to circuit board flexing and the solder joints work loose, giving intermittent operation of the wipers. A new ...
I have a 2000 chevy s-10 2.2 flex fuel motor and the computer is saying sytem to lean or to low any ideas? most common cause is the O2 sensors not reading correctly
oil coming out exhaust 2.2 liter has oil and gas mixture pushing itself through my flex-pipe right after the upstream o2 sensor. also when running smells very strongly of fuel. Can you tell which ...
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions