Questions & Answers for: Panasonic flex circuit

...or repeatable. Read that it may be a cold solder or bad cap but any clues where to start looking? Flexed the circuit board a little as well and nothing repeatable. Thanks i also suspect its just

...circuit board. To find this you'd have to pull the board and flex it slightly and/or use an insulated and non conducting object such as a plastic rod and tap the board all over until you find a ...

...circuit board which has the lens drive components on it. This is a multiconnector and care should be taken if you attempt to repair it yourself. Please check the deck for something jamming the load ...

...Circuit Faulty? so i recently aquired a CF-48 from my grandfather because of a keyboard issue, anyways it smelled like cat pee so i pulled the keyboard out rinsed it with luke warm water and allowed ...

...connects to the side PCB's. Clean the flex and re-insert, if that does not help, it is possible for the flex to have and open circuit, for the side PCB's to be faulty or even the screen to be

...Flex into the circuit board and then put the black thing back in whilst putting the CCD Flex back in, pushed it as far as it would go, then put the plastic back onto the circuit board via the double ...

...flex circuit and costs about $46 USD ( 31 GBP ) and would take 30 minutes to install. Our standard repair charge for that job is $65 ( 45 GBP ) labor. Find an independent repair shop online locally ...

...circuit boards, EXTREMELY static sensitive chips throughout the unit. And, even if you're successful in repairing/replacing the damaged part, putting the unit back together without damaging something ...

flex cables running from the bottom of the drive, to sockets on the circuit board. Gently slide each of these out of their sockets on the board. Once the screws have been removed and the flex circuits