Questions & Answers for: Nikon flex circuit

flex connector for the rear LCD panel is also on 1st circuit board (memory compression PCB). You may have a problem with the circuit board itself. There are a lot of possibilities with problems with a

flex circuit in the zoon lens that is damaged and need to be replaced. Almost always the problem of stripes in the picture is worst when you take pictures in full zoom mode because in this position of

...circuit. This is a major repair and I would recommend you go to a professional repair service.The problem in the lens can also be caused by impact (check for looseness of the mount), the ground pin ...

stability) called a FRE that has contacts on it for the ASA and aperture information to be sent to the main circuit. This is easily broken. You may also have damaged the shutter speed unit or its flex

...circuit by a flex!!!) and check the flexes and make sure they are seated properly. Then check the boards for impact damage. For more than this you should probably seek professional help, as there are ...

circuit board. Check to make sure that there are not cuts in the lands caused by impact pressing the flex into the back board components. This is a common problem with this model. Note: replacing this