Questions & Answers for: flashing temp Dryers

...temp light flashing and low coolant light flashing what could be the problem ? coolant is full and the heat works. If the temp gauge is reading normal, the lights are flashing, and the coolant level ...

Ad

...flashing.  but the temp control stays on 98 degrees instead of the 90 degrees setting I want.  What's wrong???  Balboa spa guts and panel. The keypad appears to working correctly. When ...

Ad

Flashing Temp indicator light, after 5 min on a cool morning 2002 Cabrio: Just started yesterday - Right after start-up, the lamp starts flashing. Temp gauge shows lowest mark. After running for ...

Question about Profile JTP56 Electric Double Oven

1 Answer

...temp the F2 starts flashing. When I opened the over the broiler element was on instead. We have checked the bottom element and it is fine. What could be the problem? The f2 code means that the oven ...

Question about 2000 Beetle

2 Answers

temp Flashing blue temp light = electrical fault in coolant monitoring system Flashing red temp light = low coolant level Steady red temp light = overheating Also, I would suspect that your thermostat

Question about 2000 Beetle

0 Answer

...flashing alternately with the actual water temp. I attempted to increase the desired temp but l it will not go over 70 then a CE code flashes and the desired temp goes back to 65 then it disappears. ...

Question about 2013 400 Core

1 Answer

have temp light flashing the temp light flashing even when cold Temp sensor is malfuctioning

...temp will now be flashing. Now press again, temp should increase by one degree. Each subsequent press will raise temp. If Lowering the temp was wanted, then press once and release. Numbers will be ...

Question about Laars Lite2 Pool & Spa Heater - Electronic Dual Ignition - 125,000 BT

1 Answer

...temp sensor if no flashing 1 sounds like display board you can disconnect temp sensor 2 black wires that go into power control board disconnect with unit off then turn back on if no flashing it was ...

... I shut down power for ten minutes at breaker as suggested. Cleaned all filters with vacuum. After this the system worked again with out the ten flashing green and one orange blink. (Temp ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...