Question about Lite2 LJ125 Ceramic Gas Heater
...prevents me from programming anything. Is there a way to reset the controller to stop this or is it possibly "damaged"? Thanks. see if flashing fl1 and flashing if so shorted temp ...
Question about Digital Lite2 Lj250 Btu Heater, Natural Gas
flashing info eg. temp location 188 E and time area 18:88 PM whoa bad board may be but first check the thempetore sensor is at around 10k omh if bad replace first read the manual to change the time if
Question about Lite2 175,000 Btu Propane Gas Electronic Pool Heater
temp number keeps flashing-press enter-goes back to fault 2 no ignition-sometimes temp stays-igniter shows up-clicks but burners do not go on. burners are plug with spider get a wire and bended get it
Question about AquaLink RS2/6 All Button Dual Equipment -
My Jandy Aqualink RS8 is Reading 6520 REV GG on the Inside Display Panel. It displays the Date/Time Outside Temp and Pool Temp when everything is turned "off" and after Date/TIme Outside Temp/Pool ...
I have a jandy lj175pool heater not working and the display is all lit up and flashing need temp sensor
control panel keeps flashing nothing works no power if showing fl 1 and flashing bad temp sensor
Question about Laars Lite2 Pool & Spa Heater - Electronic Dual Ignition - 125,000 BT
...temp sensor if no flashing 1 sounds like display board you can disconnect temp sensor 2 black wires that go into power control board disconnect with unit off then turn back on if no flashing it was ...
Jandy lite2 pool heater LCD display all display items light up and flash on and off shorted temp sensor un plug the two black wires on control board should stop flashing if it does replace temp sensor
Question about Laars Lite2 Lj 250,000 Btu Heater
jandy lite 2 pool heater. display flashes all segments on/off when off 114 appears on display Jandy lite 2 pool heater flashes all lighte on the off. when off 114 shows on display. bad temp sensor ...
Question about Laars Lite2 Lj 250,000 Btu Heater
...flashing. How can I check the Hi temp sensor? What other possible troubleshooting steps can I take? check safety circuit then pressure switch and wires to tight should be 24 volts ac if under 10 ...
Usually answered in minutes!
20 Questions
10 Questions