Questions & Answers for: Ariston Technologies flashing led

flashing all LED Bad control board.

We just bought a second hand Ariston Washing Machine model AVL 95. It works fine all programs, but when it goes to spin, it starts to spin, speed up, and then stops with an error (Delay Timer flashes ...

The On-Off door lock LED flashes rapidly at the same time with Delay, Timer and Rapid LED. and it wont start. Many times faults like this can be cured by Uplugging the washer from the mains power ...

...note of which lights are flashing? If you have problem with fill water than following two LED should be flashing. In this case could be: Water valve disabled Turbine disabled Control board faulty ...

...Led diode below button with the image of wine glasses means faulty thermistor NTC. So, could be faulty: thermistor NTC (defective or not positioned), wiring, control ...

..."G" flashing rapidly. Flashing LED diode above the mark 12h (drying) indicates faulty NTC thermistor. So, could be faulty: thermistor NTC, wiring between NTC and control board, control board. ...

...- probable failure of the component that detects the temperature . I suggest you to check: thermistor NTC, wiring and electronic. Rapidly flashing any combination of four LED diode means failure. ...

...flashing any of the 4 LEDs (see picture) means that the dishwasher discovered a malfunction. Depending which combination of LED flashes (one LED, two LEDs, three LEDs or all four LEDs) indicates the ...

...LED 2 (drying) flashing. Probably the siphon of the apartment is clogged. Remove the drain hose and make sure that is not clogged. Drain water in a bucket. If the dishwasher drains the water, clean ...

...flashing the drain pump shuts on off on and so Reading the error code The fault on the appliance is signalled via: 1. the continuous rotation of the selector knob 2. the action, for the first 4', of ...