Questions & Answers for: flame sensor

flame sensor on a goodman heater I know what a flame sensor is, but what we don't know is where it is located at on the goodman furnace, is there any way you could send me via-email at schewe2u2@yahoo

...flame sensor issue? Yes the flame sensor is not allowing the ignitor to start, you will need to remove the flame sensor, and clean the black carbon build up from the stem of the flame sensor, replace ...

...flame sensor?" A flame sensor is a safety device. When your furnace's main burners ignite (light Up) the flame sensor picks up the heat from the furnace's main burning and says, "YES," and sends a ...

...flame sensor PN 338906. Loss of a flame sensor signal (open) will cause the gas valve to shut off in 30 - 42 seconds How to test the flame sensor: Remove the front panel Open the top panel Leave the ...

flame sensor lights up and ignite the flame for about 5-6 seconds. Soon the flame goes out once again. There's this clicking sound that is heard every I have a 11 year-old york diamond 80 furnace. The

FLAME SENSOR FLASH FLASHING FLAME SENSOR CODE, HAS NEW BOARD AND SENSOR ON IT. A flame sensor simply "senses" a DC rectified signal from the AC spark being passed through a flame(the pilot) thus ...

Flame Sensor for Sit630 Eurosit model 0630535 I cant find just a flame sensor part which is what the heating guy said i need. Brings me to the hole mechanism. Which is the gas control valve. So is the

...flame sensor still have same problem furnace acts like flame sensor is bad, but will not code. Replaced flame sensor no change if flame sensor is new, the board may not be properly recieving currrent ...

Flame sensor light blinking on my Frigidaire furnace The flame sensor is really a flame rectification circuit. Ground to the circuit board is actually conducted through the flame to the flame sensor ...

flame sensor dirty. The furnace tries to light four times before you get the four flashes. The board then locks out for one hour unless the power is removed and restored. You could try gently cleaning