...Flame rectification is referring to a flame sensor. The flame sensor can be located on a gas furnace in front of the burners. It will have one wire connected to it. It is located at the opposite end ...
...good. Gas is on and after it tries to fire i can smell it. i do not have a pilot light as it has a direct spark ignitor sounds like a flame rectification probelm...look in the manual for ...
...is 5 years old and has had a new igniter replaced already? This is my second igniter on there now. t problem is not at the ignator but t flame rectification need ignator kit and flame rectification ...
Question about PUREX MINIMAX HEATER; THERMOSTAT, 60 CAPILLARY - 072022
...mod.#C-R407A-EN-C getting the FFL code off to start falme? indicates false flame sensing check for flame rectification not touching ground like a piece of metal dirt or has been bend on the ...
Question about PUREX MINIMAX HEATER; THERMOSTAT, 60 CAPILLARY - 072022
Does an Valliant Ecotec plus 831 have a flame supervision device. yes it does via the ignition electrode. its called flame rectification
Question about HEAT EXCHANGER ASSEMBLY, DP-350 - 10403602
...flame rectification. This could be caused by a dirty flame sensor, poor ground to burner, faulty ignition module, improper venting, inadequate combustion air, dirty burners, or clogged heat
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
what is the voltage on a pool heater flame senser jandy lx pool heater, what should the voltage be on the flame senser and what is the ohms resistance on the hsi 24 volts ac when rectifing
flame rectification" and its just microamps as the fire isnt a good conductor, but it will conduct enough for this use, try wiring some 105 degree celcius wire from the pilot assembly to the ground or
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
...flame rectification circuit. Ground to the circuit board is actually conducted through the flame to the flame sensor (ground rod) completing the safety circuit. Sometimes oxidation forms on the ...
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
...flame rectification) 7 days ago. Now noticed double cycle on startup again. This furnace has no ability to give codes. It is an Armstrong Uktra SX93. Replaced tour flame.sensor ,also you might have a ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions