...parts house for availability) If the flange is still good and the flair on the pipe is damaged you need to change the pipe. If flared on both ends or if anything is welded to the pipe, flange comes ...
...a bolt, spark plug or whatever you have into the hose end to keep fuel from leaking out. Use a flair nut wrench to disconnect the line for the carburetor at the pump. If the pump has a third
parts houses. If you have metal lines with fittings, use a flair nut wrench to remove them. You may loose a small amount of trans fluid so after doing the repair, always check the trans level. you won
...supplies in your Chevrolet S-10 - GOOD jumper cables, a blanket, water and candy bars, maybe some flairs, extra gloves, a rope, CB radio if available in your country. I hope this answers your ...
I have a 2002 extened cab the engine light just came on and all of a sudden when i am driving the RPM's will rev up a bit and then come back down it is doing it more now but when the truck is ...
Question about 2002 S-10
...only comes in straight lengthsYou know it is avail at any auto parts storeYou should know that you have to cut,bend & learn to flair tubingIt is a fabrication skill you have to learn--have at ...
...break line on dr front over tire NO Have to fabricate a 3/16" brake tubing line &double flair the endsYou don't do 10",you go back to the last fitting& remove the complete ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions
