TRANSMISSION slips between gears i have a 1996 GCL seems like the transmission is starting to slip around 25-3000 rpm could it be the vacuum shifter or something worse? slipping or flairing between ...
...on a 2001 jeep grand cherokee limited 8 cyl 4wd quad not impossible, you will need the proper sized flair nut wrench.(s) do not use regular open ends or you will destroy the nut. Make sure you find ...
...are too high, should be at 2000 or slightly less. if fluid is good and clean and shifts do not flair, check those control units. Not sure about calibrate...could mean out of calibration...Id ask ...
Question about 2002 Grand Cherokee
manual to give you some guidance, it should not be a terrible job, but may take a while. Always use flair nut wrenches on trans line fittings, Check fasteners before you start...some may be torks head
Question about 2004 Grand Cherokee
Transmission slipping or stalling around 45 mph and down shifts Transmission won't shift above 45 mph and down shifts often. Chained strainer and it didn't stop problem. What could it be and will it ...
...much all you need except that some use torks screws in the top rail and it would be wise to use a flair nut wrench to remove the trans line...There's one with a plastic clip...I dont remember if
Question about 1993 Grand Cherokee
at the line? thanks Nothing but the hose needs to be removed. Best tool for that is a "crows foot" (flair nut version). (looks like a wrench end with a provision for a 3/8" drive extension.) Available
...clamps securing it. That one is the return hose. The other one is the high pressure line, which has flair nut fittings on the ends. There is no way to repair that one (pressure will blow any repair ...
...flair nut wrench for pressure line fitting and if the new one comes without a pulley have the old one pressed on by a decent machine shop. Make sure it is set exactly where the old one was so it ...
Question about 1999 Grand Cherokee
...small wrenches to loosen the fittings Your going to need to buy tubing at the auto parts store, cut,flair & bend, as necessary, to fabricate the rusted out one your replacing,you can't buy ready ...
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions