Questions & Answers for: Brother HL fix rubber sticky

rubber part of the roller and rotate it 180 degrees from it former position which gives it a new area of wear. Usually that's a pretty good fix, and it isn't too hard to do, just make sure to note how

...rubber pad, so the plastic from clutch mechanism would'n stick anymore. http://www.phillycopiers.com/fix/hl-2040-2070-fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 3774 THE PROBLEM IS ...

...tape towards to a rubber pad, so the plastic from clutch mechanism would'n stick anymore. http://www.phillycopiers.com/fix/hl-2040-2070-fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 ...

...rubber pad, so the plastic from clutch mechanism would'n stick anymore. http://www.phillycopiers.com/fix/hl-2040-2070-fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 3774 pls open back ...

...tape towards to a rubber pad, so the plastic from clutch mechanism would'n stick anymore. http://www.phillycopiers.com/fix/hl-2040-2070-fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 ...

...tape towards to a rubber pad, so the plastic from clutch mechanism would'n stick anymore. http://www.phillycopiers.com/fix/hl-2040-2070-fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 ...

...rubber pad, so the plastic from clutch mechanism would'n stick anymore. http://www.phillycopiers.com/fix/hl-2040-2070-fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 3774 change fuser ...

...Sticky door here too, it's easy to test from the front after taking out all the internal parts that slide out. (You're going to take them out anyways to see if your issue is a paper jam, if no paper, ...

...sticky over time. Removing this rubber and stretching solenoid return spring corrects the issue. Search web for the service manual and follow chapter 8 to disassemble the printer correctly - takes ...

...rubber pad below may become sticky and retain the rocker, causing extra rotations. Slip a bit of Scotch tape over the sticky pad. A weak spring may not push the rocker up reliably. I cut a "U"-shape, ...