Questions & Answers for: fix protect mode

...protect mode and after about 3 seconds it turns off. Is there any way I can fix that? Is it doing this while you have it turned right up? Most systems have protect mode because you are trying to draw ...

protect mode try it again. Dont know if this is the proper way to fix the reciever but it worked for me. Good Luck HK protection circuits are complicated. They go into protect for overload, DC detect,

...fix it. I looked at it and the 12v cable was very loose, so i re-connected that and protection light is still on PLEASE help!!! The most common reason for an amp to go into or remain in protect mode ...

...protect mode, they normally have a blown channel. It is not an easy fix, it will require the replacement of a few parts. You would need a multimeter and soldering equipment to determain which parts ...

...protect mode how do i fix this my kenwood cd player for my car is now reading in protect mode how do i fix this i have a kenwood kdc-241 car stereo and it has gone onto protect mode i have done ...

protect mode is activated either because of a short in a speaker wire or because of excessive line voltage like the volume being too loud. atleast that the most common reasons that I have experienced.

...protect mode then that is one of two things. one there may be a power short some were in the power setup that needs to be fixed before it will function correctly again. two a fuse or a compactor is ...

in protect mode In protect mode my cd player is in protect mode. what can i do to fix it??

...protect mode how do i get it off had a blown speaker fixed it and still in protect mode Protect Mode (Blink): The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the ...

...protect mode. How do I fix this? TRY DISCONNECTING IT FROM THE BATTERY FOR ABOUT AN HOUR. SEE IF THAT HELPS. Disconnect all speaker connections and rca cables. Leave power, ground and remote wires ...