Question about 1989 Celica Liftback
...where the pipe section of the hose is that looks sort of like a trumpet end. If the fitting is in good shape, the pump fitting is clean and unmarred, you may need to tighten the hose a little
...at the rear of the cylinder heads. Install the fuel line banjo fitting at the pump. Tighten the fitting to 40 ft. lbs. (54 Nm). Tighten the fuel line fittings. Install the turbocharger
Question about products are the final word in...
i have 30 hp two stroke pull start yamaha outboard motor, the motor starts ok but does not pump water new impeller fitted, is it possible to fit it wrong? yam water pumps are clever the offste centre ...
bmw powersteering fault still no powersteering with new pump fitted Who fitted the pump? If the pump was fitted wrong it may have air in the pipes, it might need bleeding through, alternatively the ...
...fitting of the pump top plate. The oil comes out of the inner fitting on the pump and goes to the oil filter. It should to to the outside holes of the filter. The oil leaves the filter though the ...
Question about 2006 Mini
...pump...Sta-rite 11/2 hp...leaks at outlet fitting. Changed fitting twice, using teflon tape as recommended...still leaks. I don't recommend Teflon tape as it places outward pressure on the pump and ...
fuel pump part no nissan sunny model 1985 ???? fuel pump is not available in market so plz auto shop ask me plz part no and model year veh so plz u can hlp me plz send me nissan sunny model 1985 b11 I
...Steer 15 with Kohler CV15 engine. Removal 1. Disconnect the fuel lines from the inlet and outlet fittings of the pump. 2. Remove the hex. flange screws, fuel pump, and gasket. 3. If necessary, ...
Question about 2006 Mini
...pump. Fitting the pump would entail removing the blanking plate and fitting the correct studs, the insulator and the correct amount of paper gaskets so the pump delivers the correct fuel pressure. An ...
Question about 2006 Mini
I want to fit relief on pump Not equipped for that what can I do to fit valve on pump body? I want to fit relief on pump Not equipped for that in external body pump in pressure port what can I do to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions