need to know where the power control module location is. 2001 windstar the PCM is located under the hood,on the left side,at rear on fire wall.look in at the back looking over pass side strut tower.
is there a diagram to show the fire order for a 2001 ford windstar? 2001 Ford Windstar 3.8 liter V-6 VIN "4"
...2001 windstar this showed a code miss fire #3 cyl changed plugs/wires then the guy who is doing the work told me it was the cat converters so he replaced them and it still has a miss fire and runs ...
2001 ford windstar-new coil pack,new spark plugs and new wires....same problem. cyl. 3 & 4 not firing. Plugs good wires good. Getting signal from comp. to coil, 2nd coil pack. No corrorion on wire
firing order w/o distributor, the main coil dont have a numbers or any indications to change a new spark plug wiring 2001 Ford Windstar 3.8 liter V-6 VIN "4" Hope this help (remember rated and comment
2001 windstar sel motor runs but has a miss in the firing. the engine light is on, flashes 12 times on steady for 3-5 seconds then sequences again Harold It sounds like you have a bad spark plug. Take
...2001 ford windstar i replaced the plenum gaskets and spark plug wires yesterday it did a lot of jerking when i tried to start it and now my battery is dead what could have caused this May have spark ...
2001 ford windstar will not fire was running when i set up over a month ago. now it is not firing. Are you saying it will not start, or that you are not getting spark to the plugs ? Have you checked ...
2001 ford windstar turn over wont star its a 3.8 it turn s over but no fire or fuel the starter sounds funny when turning over so replaced it still sounds funny new coil pack checked all the fuses ...
...order on 2002 3.8 v6 ford windstar Your firing order of the engine is 1 - 4, 2 - 5 , 3 - 6 and looking in front of the vehicle toward engine on your coil is 1 - 5, 2-6 , 3-4. Hope this will help
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
