Questions & Answers for: Isuzu fire codes

I have a 2001 rodeo ,the car has 40500 miles on it it started missing and one cylinder did not have fire, 300, code 352 code replaced cps and coil , ran well for a coulpe weeks the same code came up ...

...fire and fuel, could it be crank sensor? Yes it could be the crank sensor.  First go to Autozone and have the car scanned for codes (free) that should indicate if there is a code and whether ...

...L Vortec 2400 gasoline engine (Ecuador only)"???? 2003, all ours are DIS fired. the spark timing, all non boxer engines (pancake) gas 4 banger's are 1,4,3,2. spark ...

my rodeo isuz 2000 eng v6 24 val is not firing rodeo Isuzu firing i need to know the problem HelloThe Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive ...

p1626 4jx1 engine will turn over but not fire. Have just replaced oil rail pressure sensor, car started and ran well, travelled approx 10 k's and parked for about 20 minutes. Car now will turn over ...

1998 firing order isuza rodeo v6 2Answers spark plug firing order ...firing order of 123456. #1 being passenger's front cylinder and #2 being driver's front... what country? spark reasons or cam ...

i have a 1997 Isuzu Rodeo 2.6L cylinders 2 & 3 won't fire after vehicle starts but will fire if I unhook cylinder 1 or 4 what will cause this Misfire in 1997 Isuzu Rodeo 4x4 3.2L - YouTube ? 2:32 ...

...will not fire up and I have been told to get the computer checked out If it were the computer, it would not have fired up after you pulled it out. Have the codes read, go after the wires or that

...fire, gas /petrol 1:low compression on the cylinder, test it. 2: bad spark on that cylinder try new plug swap with other cyl. 3: bad injection on that cylinder, , swap injectors, or test them. check ...

Good day,can you please provide the 1989 Isuzu I-Mark 1.6 DOHC distributor firing order, like 2-top and 2-down (example 1-2/top, 3-4/below) Thank you so much... you can get guide from many sites.. i ...