DOESN'T FIRE - 1 BLINK CODE THE FAN STARTS AND IT LIGHTS UP AS IF IT IS GOING TO FIRE, BUT SHUTS DOWN AFTER A FEW SECONDS. I'VE BEEN TOLD ITS A ONE BLINK - BUT I CANNOT FIND MY MANUAL NORE THE CODE ...
...spring I pucheased and installed a Goodman model GMH95 which I converted to propane. This weekend I fired it for the first time and it worked fine for about the 6 first cycles. I then noticed after ...
Question about GDS80904BNA Open Flame Heater
replaced pressure switch on my Goodman GMT090-4 furnace but will stil not fire up. When i jump the wires it fires up and runs. What are my other options? thanks Read the diagnostic code or it stll ...
Question about GMS90703BXA Heater
...codes - LED ''ON''. If power is recycled unit fires & run until T/S stops calling for heat. Then fire goes out and inducer runs continuously. Will only relight if power is cycled. it sounds like ...
furnance goes on won't fire Hello, if the burners do not fire at all there could be a few reasons, the igniter could be bad, the burners could be dirty not allowing gas to flow, the pressure switch ...
...codes. May be over fired, have airflow problem, to cause the limit to open. Next time before shutting off power, try to find the limit, it has two wires that connect to a 1.5 x 2 inch card mount to ...
Question about GDS80904BNA Open Flame Heater
...wires. it's designed to shut the unit off, by breaking the power circuit, if flame ignition causes fire to back flash out of the fire box. Press the little button and try relighting. if the roll-out ...
Question about GDS80904BNA Open Flame Heater
My Goodman Natural gas furnace GKS90703BXAG , induced draft blower runs continuously Only runs one cycle. code 2flases. No code at first. thermostat calls for heat, fires normal thru one cycle. after ...
Question about GDS80904BNA Open Flame Heater
My goodman furnace does not light . control board, venter fan and centrifugal switch were all replaced. code light show normal op but no fire Call a repair person, you must have a gas supply issue.
Question about GDS80904BNA Open Flame Heater
Goodman furnace not heating, low fire pressure switch stuck open. My furnace is blinking red three times. Flashing lights mean low fire pressure switch stuck open. Also the inducer motor does not turn
Usually answered in minutes!
1,056 Questions
416 Questions
195 Questions
147 Questions
138 Questions