Start up problem Projector turns on, eiki screen comes up, screen goes out, the warning temp. and ready light flash. Disconnected power and tried to restart, same scenerio. Clean air flow filters
...that it will act like it is going to start up but cuts off and gives a flashing warning temp light. Filters are clean and I even have an external fan blowing on it to keep it cool. Does it sound like ...
...tell me what to do and if you know the service phone in Greece? Thank you I just did it, I took the filter out and then I cleaned it. After that all I did was reset the lamp and filter times which ...
Question about LC-XE10 Projector Multimedia Projector
...Green "Ready" light and Red "Lamp" light are on... Have tried the reset button and cleaning the filter... no result Please check on of these solutions : 1:Remove the lamp from the projector. ...
Question about LC X986 Multimedia Projector
Eiki LC-X986 - How do I get to the filter to clean them At the side of the carrying handle you can pull out two grey plastic frames, these are the air filters, If just dry dust, clean with air or ...
Question about LC-XB23 XGA LCD Projector Multimedia Projector
...light would continue to flash red and the power light would be solid red. You should clean the air filters. The filters are located on the underside. Disconnect all cables and invert. remove the 2 ...
temp warning light and ready light flash no start up one of the sub-powerlines have been shortcircuited by defective smd capacitors. this results in powerfail mode with leds blinking
Question about EIP-2500 Multimedia Projector
How to remove top cover of Eiki EIP-2500 projector loosen all the screws from the bottom ( one is in the middle) and two at the back ( edge) press the grill on exhaust fans side near the heat warning ...
why won't my warning light turn off? why won't my warning light turn off? Probably a fan that doesn't rotate, or one of the many sub-voltages is absent on the mainboard due to short ...
Question about LC-SE10 Projector Multimedia Projector
My EIKI projector won't turn on.After hitting the power button it will begin to start but after about 10seconds the fan will start running real fast and then will stop and the warning light comes on. ...
Usually answered in minutes!
18 Questions
15 Questions
12 Questions
12 Questions
10 Questions