...is likely blocked. access is not that easy. take off panel at bottom rear. filter is in pipe from bottom of tub to pump. undo this pipe, take out filter. you may have water everywhere so be ...
...the pump filter, or pump, outlet pipe, or U-BEND. Don't forget to rate! i have a hotpoint aquarius 740 when i press button to start wash all lights start flashing and i cant turn it of , any help
Question about Ultima WF860 Front Load Washer
...out and i have checked the pipe no filter but pump may be plugged remove front panel pump om right side ..to remove panel putty knife press hidden clips under front edge and pull panel ...
...will see a large diameter pipe going from bottom of machine to pump. take off this pipe at the machine end - careful, lots of water may come out. filter is located inside this pipe. remove and ...
...filter is in this pipe. If this is clear take off other end & check pump is not obstructed.Be aware that there will be water in these pipes so may be wise to take machine outside.Let me know if ...
Question about Ultima WF860 Front Load Washer
...and clogs up. remove the pipe and clean the filter out and remove gunk from the pressure sensor on the side of the pipe as well. If that does not fix things the pressure switch could be faulty ...
Question about Ultima WF860 Front Load Washer
...filter on my Hotpoint Ultima Super Quiet washing machine On this model i believe the filter is in the pipe below the tub this pipe needs to be removed from the tub side be sure to fit pipe back ...
Question about Aquarius WF000 Front Load Washer
...machine The filter is underneath the machine,tilt it backwards look underneath and you will see a rubber pipe with a plastic inner with a clip on the end. Undo the clip and slide the filter
Question about Aquarius WF000 Front Load Washer
...pipe over the plastic bits on the filter. Filter should then just pull out. (Give the condenser pipe a good clean out whilst it's off). Put back together making sure the condenser pipe is secure on ...
Question about Aquarius WF000 Front Load Washer
...but the clothes seem very wet . WATCH AND LEARN https://www.youtube.com/watch?v=86hYg6a6AJE Lift your Machine's drain pipe and end of it must be having a filter like end plate, get rid of this
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions