Questions & Answers for: Admiral filling loop

...but the tub only is 1/2 full. If the water level control is set to a low level, the water stops filling and the tub begins to cycle That is because the water level switch get stuck when water ...

...filling. It is as if the water is leaking out of the tub as it is trying to fill up Check the drain hose to make sure you have a high loop, ie. make sure the drain hose loops above the height of the ...

...back up after the rinse cycle begins. Today I started my washer at 3:30 and it still hasn't begun filling up with water. Remove the fill hoses from the back of the washer and check the inlet valve ...

Washer fills, but doesn't stop filling... Our washer will fill and keep filling till overflowing. The cycle won't start, but will spin if you put it there by hand. I noticed today that there is some ...

...tub only is 1/3 full. Even if the water level control is set to a low level, the water never stops filling! Help - can I fix this problem at hime myself? The water is siphoning out as it fills. Your ...

water fill doesn't shut off .have a sanyo model sw1100p need to replace that fill valve it sounds like it is not closing... it is where your fill hoses are attached to ...

...the hot water pressure (UK) Switch over the inlet pipes ie hot to cold and cold to hot and try filling the machine when switched to fill with hot water, (machine will fill will cold). proving

over filling Hi, If you have a problem with your washer or dishwasher continuing to fill with water after the valve has closed, then you this tip will help you understand why that is happening. Washer

Why won't my washer fill up with water on the rinse cycle? It only will fill to the lowest level. I have to put in on the wash cycle to fill up properly, then switch it over to rinse something ...

Why does my Admiral washer fill then stop on wash cycle to fill again? It starts wash cycle but wont agitate or wash. I hear motor trying to cycle but it stops and starts fill again POSSIBLY A BAD ...