Questions & Answers for: feed dogs low

dogs are worn. The feed dog feeds the fabric under the presser foot while you guide the fabric. The feed dog regulates the stitch length by how much fabric passes under the presser foot as the machine

my feed dog control stopped working...it wont put feed dog up it stays low.. if so, do not place them too low. make it all becomes easy.

pfaff 1229 feeder dog too low if you have a manual to see where the feed dog lever is, to see if it's in the up position, if not have the machine checked to see if the feed dogs need to be ...

...shows you where to flip the lever to raise the feed dogs. If your feed dogs are not grabbing fabric your feed dogs are lowered. ...

...feed dogs to see if they are rising above the needle plate at least 1 mm. If not rising lint may have felted between the feed dogs and the needle plate. It could also be the feed dogs have been ...

...feed dogs in all Classic Bernina machines from the 130-180's will eventually come out of adjustment. This is due to the so-called cost savings modern manufacturing method of drilling holes in the ...

...feed dogs have not been dropped for darning or free motion quilting. If the feed dogs do not rise above the needleplate, they will not pull the fabric through the machine. Feed dogs do wear (which is ...

...feed dogs are lowered to do darning. Here's a manual: PFAFF 294 Instruction Book Page 11 See if the A/B switch makes any difference in the feed dogs. Sometimes these old machines haven't been oiled ...

...feed dogs. Replace open arm cover and the feed dogs at the highest rotation should be the height of a dime above the needle plate. If this is correct then done. If the feed dogs are still to low ...