Question about 15208 Mechanical Sewing Machine
...feed dog does not move the fabric forward or backward,if this is so try to run machine w/o the fabric check if feed dog move on cycle,the teeth should be moving upward and downward rotation pushing ...
feed dog is stuck in the down position. Embroiders fine, but can't sew.I have tried the manual button, it moves back and forth, but doesn't move the feed dogs. Have cleaned the area. What next? if the
Question about Memory Craft 10000
pfaff expressions 3 feed dogs will not raise when switch is moved right Manual says, to raise feed dogs move switch on front of machine to the right. This does not work. Feed dogs will not rise. If ...
I have a singer 543 the feed dogs won't move. singer stylist 543 the feed dogs are frozen they will not move at all why? I suggest getting out your manual and looking up lower and raising the feed
...dog feed won't feed material. check to see if the feed dogs lever is in the up position for sewing, if not move the lever to the up position, if the feed dog lever moves and it doesn't make the ...
Question about Memory Craft 10000
...below the needle plate, and the feed dog lever does not activate them, then perhaps something is disconnected in the feed dog mechanism. The feed dogs should rise when stitching
Question about Memory Craft 10000
feed dog if that is the problem Is the feed dog raised into sewing position and not dropped as for darning? Feed dogs need to be in the raised position in order to pull the fabric through the machine.
Question about Memory Craft 10000
...feed dog lever won't move to drop dogs for FMQ. Any suggestions? Thank you Most likely the feed dog mechanism was not lubed enough to overcome the old oil that has turned to glue. It is very common ...
feed dog is up but has stopped feeding Are the feed dogs moving at all--like moving toward the back of the machine, dropping down below the needle plate, moving forward, rising, and then moving toward
Question about Memory Craft 10000
...feed dogs are moving. Open up the bobbin compartment and clean out any lint, thread or other debris that may be tangling the mechanism. Take off the throat plate and check the feed dogs. A damaged ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions