Questions & Answers for: Panasonic favorites bar Vacuums

my Panasonic performance plus platinum vacuum cuts off and on while using the beater bar, this doesn't happen at all using the stair cleaning attachment. It appear electrical contact is being lost ...

MY VACUUM IS NOT PICKING UP IV BOUGHT NEW BELTS FOR IT I CANT FIGURE OUT WHERE THE SMALL BELT GOES...COULD YOU PLEASE LET ME KNOW WHERE IT GOES..... Hi This is quite complicated but I'll try and ...

Better bar doesn't rotate, kenmore whispertone 100 Better bar just stopped rotating. Can I fix this? Most likely your belt wore out and broke. Here is a handy vacuum repair tutorial that should get ...

Beater bar not rotating The beater bar stopped rotating and I need to check the belt but I don't know how to open up the whispertone 100 Remove the screws from the bottom of the power head.

the beater bar isn,t turning on my panasonic MC-GC467 IS THE BEATER BAR SUPPOSE TO TURN Ya, you probably need to replace the belt. You can get replacements here: Replacement Vacuum Belts

the brush bar wont turn when hoover is turned on First check that there is nothing wrapped around the brushes that are stopping it turning. If that is all clear, check the drive belt for the brush bar

need beater bar for MC-V5750C Do you mean the agitator? All parts are available at the link below. ...

installing new belt +++++++++++++++++++++++++++++++++++++++++ +>> Unplug the mains lead from electrical socket <<+ +++++++++++++++++++++++++++++++++++++++++ • Turn cleaner over in flat ...

panasonic optiflow upright vaccum how do I replace the belt? Hello, Put the vac on its side and remove the screws holding the cover plate on. This exposes the beater bar and belt on the side. Pull the

How do I replace small belt on Panasonic MC-UG304? Do you mean the beater bar belt or the motor shaft belt? If so, you need to set the vacuum in a horizontal configuration and turn the vacuum upside ...