Questions & Answers for: Volkswagen Golf fault codes

...fault detected 00532 007 supply voltage too low. hope you can help Thanks in advance Bob Randall Try first unplugging battery cable for ten minutuse, to reset ECM, and do a scan again, there are too ...

Ad

Question about 2004 Golf

3 Answers

Emissions garage fault. Hi, I have a mk 5 golf 2.0l tdi 4motion. When I start the car the engine management light stays on and a message on the screen says "Emissions Garage". I had this fault about ...

Ad

Question about 2001 Golf

1 Answer

FAULT CODE: P0601 light staying on dash fault code is: FAULT CODE: P0601 ENGIN CONTROL MODULATER MEMORY CHECK SUM ERROR fault code:po234

Question about 2001 Golf

1 Answer

...ideas on cause ? thanks tony go to ! obd-dot com these code are not always a problem is saying a pc fault, or connection fault. check no earth leads were removed when work done, on suspension leg, ...

Question about 2005 Golf

1 Answer

Engine fault Garage warning sign on Volkswagen Golf 5 " Engine fault Garage". what is the problem, please helP! you just have an engine code. connect a scan tool and pull the code. write down the code

...a generic fault code reader it may not extract all the codes. Vagcom or VCDS is required. If engine management light is on there must be a fault stored but your fault code reader is not displaying

Question about 1998 Golf

1 Answer

2001 golf gti had fault code p0420 come up had new rear lamda done still p0420 so got new front lamda, code still come up so then got a new cat, then fault code p0420 and p0120 come up,, then had new ...

Question about 1998 Golf

1 Answer

...fault codes NOT the fault.so when youve checked it out get back with the codes so that we can give you itemised fault remedies.(as the machine is quiet expensive,i sometimes suggest that you get a ...

vw lupo engine code fault 17852 this code is not listed in code book It is a manufacturers fault code, it means implausable signal from G212 In English that means replace EGR valve :o)

Question about 1991 Golf

1 Answer

...you must do a fault code test, once you have the fault codes you do the required fault codes testing per the factory service manual and replace or repair the problem(s) that caused the loss of

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...