Questions & Answers for: Jeep Grand Cherokee fault code

Question about 1997 Grand Cherokee

2 Answers

...Fault code Display process is finished. And for the CEL ( Check Engine Light ), it is caused for the codes 12, 42, 45, 46. Code 55 is not a fault code as I wrote above. Call a mechanic to correct the ...

Ad

Question about 2000 Grand Cherokee

1 Answer

...fault code is stored in memory and the ABS system is disabled. If a hard fault is detected while the vehicle is being driven, a fault code will be stored in memory, the ABS warning lamp will come on ...

Ad

Question about 1996 Grand Cherokee

1 Answer

...fault code is meaning. Most dealers will read it for free, and then charge for the repair from that point. If it was a false code they will also reset it for free. If it is an orange light, just get ...

...55 Completion of fault code display. 62 Unsuccessful attempt to update EMR mileage. 63 Unsuccessful attempt to write to an EEPROM location by the controller. 76 Fuel pump resistor by-pass relay ...

...Fault Code 41 Description: Alternator field control circuit open or shorted Power loss light: Off Limp-in mode: None Possible Causes * Bad connection or wiring - Check the wiring and connections ...

...fault code, but sometimes they donĀ“t. So first check if there is any fault code set in the PCM with a scanner or using the key dance: ignition switch three times off/run and leave in run at the third ...

Question about 1993 Grand Cherokee

1 Answer

this Greg thanks . how do I clear the code? Clearing CodesPrint Stored faults should only be cleared by use of the DRB-II or similar scan tool. Disconnecting the battery will clear codes but is not ...

...fault code set using keydance: ignition switch off/run three times and leave in run at third time. Odometer will show Done when no faults, or a fault code(s). This many times is a problem with crank ...

Question about 2001 Grand Cherokee

1 Answer

fault code P0107 in 2001 grand cherokee fault code P0107 Code 107 means the MAP sensor signal is low. The problem could be the sensor, the wiring, or a major vac leak.

Question about 1999 Grand Cherokee

1 Answer

...some one told you XYZ fault code = replace ABC part) you thought were causing the problems and you are still getting the CE and fault codes then your diagnosis of the problem was completely

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...