15 mintues and then goes into a H and flashing 'E' fault. This fault isn't listed in the manual. Happy to be of some help. Please keep this list around so you can take notes if the problem comes back.
Question about 37LP1D 37 in. LCD Television
...15 times and then stays on but no picture i have been trying to figure it out and have had it working but wont stay working. The power supply is a common fault on this model. Buy a replacement from ...
Question about 15LC1RB 15 in. LCD Television
through the channels or more commonly when you use the digital text function. It is an intermittent fault but most annoying as you have to then retune all the digital channels each time it happens. We
Question about 32LB1D 32 in. HDTV-Ready LCD TV
can't get channels 12 15 and 24 since retune all other tvs ok that run of same areial TUNNER OR TUNNER SUPPLY FAULT
...15 minuts Possible that there is overload and it can trip the motor. You need to observe this to confirm. Also check for free movement of the rotor and the motor drive.Finally a fault on the ...
...seem ok, thanks a lot. A blown capacitor might not be the reason. After 15 to 20 minutes of work, the temperature inside the set do rises much, this kind of fault can occur. Check its cooling
...fault finding LG 42LG5000 4 years old When switched on left-hand side of screen dark and muddy looking, sometimes with ghost of previous images and with white horizontal lines stretching half way ...
Question about MZ42PZ10 42 in Plasma TV
...15 min, the right side of the tv is full of green stripes. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. ...
Question about TROMM WM2688H 4.0 cu.ft. Front Loading SteamWasher
the door and start a wash cycle keeps going off even though the washer is empty. We hear it every 15 minutes or so. Any help would be appreciated This fault is mostly pointing to the lock/latch sensor
Question about TROMM WM2688H 4.0 cu.ft. Front Loading SteamWasher
...15 months old so just outside of warranty and ive pulled it appart and cleaned the ribbons attaching to the tcon board with use of a new pencil eraser and reattached and the lines still continue, The ...
Usually answered in minutes!
236 Questions
209 Questions
138 Questions
140 Questions
116 Questions