...fuel pressure guage installed a very long time ago to alert me of failures. The 4th go around I installed the FASS and now it maintains 21 to 27psi even with chip mods switched to extreme! I am still ...
...fuel pump system but problem still there. Anybody got a clue? install a intank lift pump its not the lift pump i been dealing with it for a year now and no help from anybody just a bunch of parts ...
...fuel pressure problem. I replaced my stock transfer pump with a FASS DDRP from www.usdieselparts.com. The stock pump is over $200 to replace and will fail again, sometimes right out of the box. The ...
...opposed to mechanical, pre '99?)I would recommend you bite the bullet and install a Fass fuel pump. My truck is an '02 with 750,000kms. Since I put on the Fass, at 591,000, I have had nary a
...fass fuel system,if the lift pump went out and you replace the injection pump it will ruin it in a short time. The injection pump is not an easy job to change or for a novice mechanic as it has to be ...
Question about 2004 Ram 2500
...fass fuel lift pump wen bad replaced it with in tank fuel pump and its pumping fuel but wont start it has smarty jr and un tuned it stil wont start ? suggest that you bled the system including the ...
Question about 2004 Ram 2500
...FASS Adjustable fuel pump in June of 2013 from the onset i lost 3 to 5 miles to the gallon and the pump was very loud. Now the pump is extremely lound and has set a check engine light on my 04 Dodge ...
Question about 2004 Ram 2500
...fuel problems, it will lose prime in the cold weather. can reprime system and it will run for a week or two. i need help please. replaced the cp3 pump, filter head, all the rubber lines, pressure ...
...fass fuel pump . Truck will turn over but wont start checked fuses and grounds all good . Any ideas would be helpful thanks here's a website that has all this information about all this and manuals ...
Question about 2004 Ram 2500
...should be able to hear it running. I replace the factory fuel pump on mine with a Fass pump and used a small relay to power the Fass pump without using the ECM and it works great. Keith
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
