...(Only 2 wires going to the plug) is the fan power cable. Jiggle it while the fan is on position number3 so you can hear when it comes on!!! need to replace the blower motor speed control
The fan will work only at position 4 (maximum), is it the control ? its the resistor. its located down to the left of the blower motor, 4 wires.
fan control only works on high in a gmc 2005 canyon Replace the blower motor resister,it is mounted right next to the blower motor,it has a lug with about 7 wires on it.Just unplug it and remove two ...
...under the glove box that loosens and you need to snug it up. The resistor block that control the lower fan speeds is bad. the climate control fan on my 3005 gmc canyon only works on the highest ...
Sierra 1500. The blower stopped working on #5 first, then #4, now all is out. Where is the resistor located? Try checking your speed switch which should be located under the dash on the passanger side
...but does work on 4/hi this is only the fan/blower. what causes this& how do I fix it? replace blower motor resistor located near blowermotor I have the same problem... how much was it to
...GMC Canyon are located in the engine compartment fuse block.This subject is covered in the 2005 GMC Canyon Owner's Manual on pages 5-98 through 5-102.If you do not have an Owner's Manual, you ...
...located on a 2005 gmc canyon truck rough idling have replaced the spark plugs, all ignitions coils, oxygen sensor idles very low The 5 cyl engine looks like it is mounted on top of the exhaust ...
canyon no voltage at heater resistor heater not working at all no voltage at heater resistor with key on or off The resistor provides the ground circuit for the blower motor. So you would need to have
...a problem on my 2006 sierra, the fan wouldn't work on 5. gm had a curtisy recall, they had to replace a resistor, at no charge, last week. Ask your dealer about any recall for this with your
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions