Part # for a Y Sustain Board Cable Ribbon Board = LG 6871QYH039B Model = 50HP66 Plasma TV need to replace the cable ribbon connecting the Y Sustain board and the Top Y Drv board. For reference, the ...
Question about gigabeat S MP3 Player
will not turn own it reads contact manufacturer for repair. My toshiba s will not turn on or off. It reads contact manufacturer for repair with a yield sign with the number 5 reading inside the yield ...
Question about Satellite M65-S9092 Notebook
Toshiba screen goes blank when it is opened too far Toshiba Satellite M65-S9092 This is a laptop and when I open the screen too far it will go dark. Then I have to keep pulling the screen forward ...
How do I remove and replace the keyboard on my satelite A 120 laptop. Can I have some instructions please. Hello, Step one: Remove the two screws from the bottom of the computer that are holding down ...
large flat ribbon cable holding it to the motherboard, (so don't pull on it as you will break the connector) unclip the connector and the cable will fall out. To fit is just the reverse. Good luck
keyboard ribbon connector on the motherboard need the retainer cable lock clip for the keyboard connection ribbon to the ribbon in to the motherboard connection Cut a piece of sturdy clear plastic ...
Question about Satellite A205-S5831 Notebook
Added new water dispenser paddle, now no water and ice auger runs contimually! Frigidaire PLHS69EESSN side by side aprox 5 yrs old Plastic water dispenser paddle snapped off. I replaced with new one ...
Ribbon rewind does not operate, labels print but ribbon comes out the front of printer with the label? Have you selected thermal transfer in the driver? This is the normal cause for ribbon not ...
Question about Sm-352 Cd-rw/dvd Drive
Do I connect the cable from the motherboard (that has a 4 pin male connector) to the drive, or does ONLY the ribbon cable and the female power connector attach to the drive? I connected the ribbon and
Ribbon Error 1 - Toshiba B-SA4T series I have fully calibrated the the printer, I also have done the sensor alignment for reflective. On the printer driver, I have selected Thermal Transfer. Every ...
Usually answered in minutes!
405 Questions
364 Questions
299 Questions
263 Questions
243 Questions