Questions & Answers for: Jenn-Air f3 code

Code F3 So, we followed your advice on the last solution. We replugged the J-2 harness and the probelm continued. Then, we pulled the thermostat sensor and will replace it. Now, the oven cleaning fan ...

Code F3 continuous beeping Any idea what it might be? Thanks a lot! HI thanks for your question.. code F3 says to replace the oven sensor ,located in the oven. top left corner. replace the oven sensor

f3 error code I REPLACED THE OVEN SENSOR AND STILL RECIEVING F3 ERROR CODE AND THE COOLING FAN IS RUNNING Check the connection from the temp censor to the board. A break in the wire will cause the F3 ...

...F3 fault code description is an open or shorted oven temperature sensor. Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if ...

...code f3----so we did what it said and pressed cancel for a few seconds and it didnt make a difference----so we sent for a new sensor and put it in and the temperature seems to work but the fan still ...

...We turned off a breaker and tried again- same problem. F3 and fan runs continuously Hi, code F3 says to replace the oven sensor, located in the oven at the top left corner. Replace the oven

...F3 error code and F1 error code F1 Defective touch pad or clock (ERC) Replace touch pad or clock (ERC). Touch pad is a more common problem. Refer to F1 test at the top of this page for more ...

...Air electric oven model JJW927AAW. Serial number 11993640WO HI thanks for your question.. code F3 says to replace the oven sensor, located in the oven. top left corner. Replace the oven sensor. ...

...we put in any numbers Hi,i have posted this tip that explains what the F3(and F4) error code means and what to check to fix your ...

...F3-1 code I replaced the touch board and the short sensor and I still receive an F3-1 code. oven heats to temp but beeps and shuts down after about 45 minutes Typically this code is cause by a bad ...