Question about Ariston Aquarius WD420 Front Load All-in-One Washer/Dryer
...f06 lights 2&3, N/A? f07 lights 2&3&4 heater relay f08 light 1. heater relay f09 lights 1&4 eprom/setup error f10 lights 1&3, pressure switch not sensing f11 lights 1&3&4, ...
Question about Ariston Aquarius WD420 Front Load All-in-One Washer/Dryer
...f06 lights 2&3, N/A? f07 lights 2&3&4 heater relay f08 light 1. heater relay f09 lights 1&4 eprom/setup error f10 lights 1&3, pressure switch not sensing f11 lights 1&3&4, ...
Question about Aquarius WD640 Front Load Washer/Dryer
...F06 on my Hotpoint WMf740 machine, what does this mean? Hello, F6 error is apparently a motor fault. The motor could be jammed, open circuit , burnt out. It may just be a broken wire or connection ...
Question about Ultima WF860 Front Load Washer
...F06) error code is likely a loose connection in the harness between the motor and the (MCU) or between the (MCU) and the (CCU). It could also be the tachometer circuit in the motor or an intermittent ...
at end of washing error code flashesf06 why does error code f06 flash up on my washing machine Hotpoint uses different error codes for different models. Can you post your model number?
Question about Ultima WF860 Front Load Washer
...Error CodesF01 - Electronic circuit board fault F02 - Motor circuit fault F03 - Temperature sensing fault F05 - Waste pipe blockage or pump issue F06 - Door lock fault F07 - Electronic circuit board ...
Question about Ultima WF860 Front Load Washer
...error code F06 and has flooded my kitchen due to the water from my machine expelling through the kitchen sink during the cycle thanks Please check for rodent nest. For some reason bugs and small ...
Question about Ultima WF860 Front Load Washer
...error code Hi, F06 is a water level fault. It will either be due to a faulty vacuum switch (which is the hockey-puck thing with the little tube to it, or it will be not draining properly because of a ...
Question about Ultima WF860 Front Load Washer
...error f06 appears on display of ariston hotpoint model wdg8640 I unplugged machine for two min replugged and the error is still on and door does not open correct only by pulling the manuel lever and ...
Question about Ultima WF860 Front Load Washer
F06 - Door lock fault. Issue: Washing Machines door cannot be opened or closed / when the door is closed the machine the programme will not start. Advice: If your washing machines door will not close,
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions