Questions & Answers for: Dell exit sensor jam

...jam I check and still the message comes out to eliminate paper.I unplug it and still same message. All it takes is a small piece of paper or other foreign object in the rollers somewhere, or if by ...

sensor board will have to be replaced. If the exit rollers are not turning and the paper does not make it into the fuser, I would suspect one of the gears on the fuser has failed. Remove the fuser and

jam. but when i print from drawer tray the paper stucked from back under the fuser There is a sensor in the back that lets the printer know the paper has exited the fuser. It is probably broken off if

Jams My printer is dell laser 1700. paper is always jamed on the exit rollers Check the sensor at the rear of the fuser. Sometimes sensor gets stuck.

a problem with the paper exit sensor on the fuser unit. We have many of the 1700N printers and have seen several times that the paper exit sensor actuator arm gets broken off when removing a paper jam

...stops and registers paper jam! dell 1710 laser http://www.fastprinters.com/ProductDetails.asp?product_id=LEX-56P1826 Exit sensor is broken , look for the same part for a Lexmark E330 if the URL

...is on the back of the fuser, it's the small black plastic piece that the paper hits as it passes through. (or is supposed to) online suppliers have this part for under $40 us. it's an exit

...sensor on fuser exit door. If i select duplex on panel it will throw code again. hey just open the back door of your printer remove the jammed papper...den resart your printer n then ...

...sensor on the rear cover of this printer. To open the back cover and remove any stuck paper, perform the following steps: Open and close the front cover. The jammed paper may automatically exit the ...

...printer showing paper jam when there is no paper Out put sensor is broken try to fix it.Is in fuser part. I would search for any bit of paper stuck on the exit route near before or after the