Questions & Answers for: exhaust cam to

...cam and exhaust cam are on the same side of the vehicle. Facing the engine, the "upper" cam sprocket on that side is the intake cam, and the one that is lower and farther out toward the fender of the ...

exhaust cam and at 3 O'clock on the intake cam should align with the top of the head. If stock timing is altered the exhaust cam punch mark will either be one tooth above or one tooth below the top of

valve timming which marke on rotor and which cam is exhaust and which is inlet The inlet cam is on the Inlet side whereas the exhaust cam is closest to the exhaust manifold.

...dodge 2.7 liter, between the exhaust cam and intake cam???? HELP!! Here are the diagrams for the secondary timing chains (exhaust cam - intake cam) and the primary timing chain. (courtesy of

...exhaust cam wheel it says inlet so this pòints to inlet cam wheel and the inlet cam wheel that says exhaust points to exhaust (twin cam per head ) have a play and if you cannot do it then post ...

...exhaust cam moving round ready to rock on to the exhaust valve as the piston rises to the top again (4th stroke exhaust) as the exhaust valve lobe rocks off the intake cam lobe should be starting to ...

exhaust cam position actuator location? I ASSUME that this has the 2.4L ecotech 4 cylinder engine?? If so the vct solenoids (variable cam timing) are mounted between the intake and exhaust cams ...

exhaust cam out about 5 degrees. loosened exhaust cam pulley re timed with alignment tools and rotated crank 2 revolutions and again found the exhaust cam out of positions about 5 dgrees. wondering if

...Exhaust Cam Timing Mark to mark on #1 Exhaust cam cover, then take up slack between Exhaust & Intake Cams (on top between the cams), Then align the Intake Cam to mark on #1 Cam Cap, "Now" loosen ...

...of the piston for a twin cam engine the cam lobes position will be the same operation just that the inlet cam rock will be for the inlet cam and the exhaust cam rock will be for the exhaust ...