Questions & Answers for: etc relearn procedure

...Relearn procedure "Make sure that all accessories are turned off, a.c. radio, lights etc.." That is very important as the bcm will learn the wrong idle speed and you will find yourself in the same ...

...etc. come on. I get nothing. No clicks. Battery alternator good. Fuses all good. You could have a start that has gone bad and will need to be replace,or your having a Passlock system problem. Your ...

etc. Just replaced the battery and even checked it with multimeter. Here's what happens at startup: Key in ignition: nothing Key up to accessory: battery light Key up to ON: battery + security + check

...ETC RELEARN function. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Go To 4 NOTE: Remove the jumper wire before continuing." ill stop here, (i ...

...do i get the coputer reflash Performing the following repairs may require you to initiate a computer relearn procedure in order to restore proper vehicle operation. Engine replacement ETC.

...relearn by itself. The technical service bulletin about this issue says that the software is glitched and that after cleaning the throttle body, the Power Train Module (PCM) needs reprogramming with ...

...anything else to access the knock sensor? Was the battery disconnected? If so, a relearn procedure may be required for trans module etc relearn shift points while you drive the ...

...relearn procedure then you will have to drive the car under all conditions from cold to hot and short to long distances as well under different throttle conditions. etc, idle cruise acceleration and ...

...etc everything on all vehicles. must check it out common with Kia Optima...it needs updated software AND a reset of the relearn module. 1.Transmission Software update. 2. (impt!)make sure they ...

...position relearn? If this procedure was done and still failing then likely an intermittent circuit fault (broken wire, bad connection, etc.). If relearn was not executed then it's a more likely