Questions & Answers for: Nissan Pickup error code 12

...error code refers to "Swirl Control Valve Control Solenoid Valve". Additionally, you might find this link informative of other Nissan related error codes. Corrective measures would require ...

Ad

Question about 1992 Pickup

1 Answer

air conditioning The A/C recently has quit blowing cold air. The light comes on and acts as though the unit is working, however, no cold air..The people at Auto Zone said something about it having to ...

Ad

...error code 45 1991 nissan d21 4cy 2wd Engine runs rough and stalls, I get error code 45, injector leak. Should I replace the injectors or is there a way to solve this problem. What are the procedures ...

i have a 1985 nissan truck with a 2.4. it will crank when cold and sound as if everything is correct, but as soon as it warms up it shuts off and will not idle any at all. the truck will still crank ...

2000 nissan frontier died on road. hum at fuel tank for few sec, no spark, 12 v at coil with ign on. only code was knock sensor, which has been there for some time. what next? check timing belt

...Code 12 -- Air flow meter malfunction. Code 13 -- Water temperature sensor circuit malfunction. Code 21 -- Ignition signal malfunction. Code 23 -- Idle switch circuit malfunction. Code 24 -- ...

how tight do i tighten front wheel bearing on 1996 nissan pick up Using a torque wrench, tighten the nut to 12 ft lbs. once all is back together new grease, clean bearings, and such. Tighten to 12 ft ...

Question about 1997 Pickup

1 Answer

error code P1330?http://technoanswers.blogspot.in/2012/02/2003-kia-sorento-shows-error-code-p1330.html--------OBD code P1330?http://technoanswers.blogspot.in/2012/02/obd-code-p1330-on-2003-kia-sorento

Question about 1997 Pickup

1 Answer

error cod 12 PO100. what is the problem of my car P0100 NISSAN - Mass Air Flow Sensor Circuit Range/Performance ErrorPossible causes- Dirty mass air flow sensor - Dirty mass air filter - Mass air flow

Question about 1997 Pickup

1 Answer

...code and it points to the evap system. I want to make sure I am testing this thing right. I took it off and blew into one end (the hose end that goes to the engine) it came through the port that goes ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...