Questions & Answers for: Chevrolet 2500 error code 12

...plate over the port. Additionaly someone removed the map sensor DTC - 15 Engine coolant temp sensor error (low temp indicated) DTC - 22 Throttle position sensor error (signal low) DTC - 33 MAP sensor ...

How to piggyback two 12 volt automotive batteries for extra cranking amps, but keep them 12 volt. positive to positive and neg to neg ,easy The batteries should be wired in parallel to one another. ...

code 12 (one flash followed by two flashes a few seconds later), and flash this three times. After the third time if any other codes are present they will start to flash (also 3 times). The diagnostic

no gas getting to carb. change relay,,fuse pulled sending unit and pump tested pump pumps good OK well first its not a carburater , it is throttle body feul injection.If you are pumping the pedal ...

...error code you need to check on the ECB inputs if there is a fault or error that switches off the ignition circuit. Hence even jumping the connection to the fuel pump will not initiate the engine. So ...

when in fwd I have no rear wheels engaged,only front wheels engaged.I have the transfer case apart and the range and mode shifting forks look like new sincros look good as well.what am I over looking?

error code P1330?http://technoanswers.blogspot.in/2012/02/2003-kia-sorento-shows-error-code-p1330.html--------OBD code P1330?http://technoanswers.blogspot.in/2012/02/obd-code-p1330-on-2003-kia-sorento

will not start I think I have the wires wrong from starter to battery should both pols on starter be hot at all time The heavy gauge wire (Thicker one) is attached to the battery and carries 12 volts ...

...Code 12. The code will display as one flash, a pause and two flashes. Code 12 is not a fault code. It is used as a system acknowledgment or handshake code; its presence indicates that the ECM can ...

2001 Chevy Silverado 2500 hd 8.1 liter crank but no start Any info Check the ignition switch in the start position and see if you still have 12 volts.