Check engine light is on, engine weak and missing Check engine light is on, the engine is weak/missing on at least one cylinder ''i think''. i checked all plugs and wires. it's a 1998 4.0 4wd put a ...
...engine code P1400 . What is differental press feedback EGR circuit low input? We replaced EGR valve, cleared the code and drove car 2 miles and light came back on. This may have to do with a bad ...
...engine wiring and vacuum hoses which will interfere with engine removal. Position the wire harness out of the way. On 1996 Explorers with the 5.0L engine and all 1997-99 Explorer/Mountaineer models, ...
...not a sohc. looks like wiring is different. how/can this be done? short answer, no. the entire engine wiring harness / ECM would need to be replaced / modified. possible? yes. but quite a bit of
i change the spark plug and after starte to shake ann act weir and check engine light came on Did you gap the spark plugs, or did any of the spark plug wires get damage while removing them, or did a ...
trouble code P0320 ignition/dist. engine speed input circuit P0320 - Ignition / distributor engine speed circuit malfunction The ignition engine speed sensor input signal to Powertrain Control Module
...wiring does not match, make notes in your book to reflect how your engine is wired. Fig. 1: 1991-94 2.9L and 3.0L Engines Firing order: 1-4-2-5-3-6 Distributor rotation: Clockwise Fig. 2: 2.3L, 2.5L ...
connect one end to negitive battery terminal and the other end to a good clean metal bracket on the engine and then try to start the truck if it starts then its the ground to engine thats bad, this is
NEED WIRING DIAGRAM FOR 02 FORD EXPLORER 4.0 SOHC ENGINE NEED WIRING DIAGRAM 4.0 SOHC ENGINE Wiring about what?
Where is the camshaft sensor on a 98 ford explorer 4.0 On overhead cam engine--top rear of engine--2 wire connector--wire colors--dark blue/orange--and gray/red------On overhead valve engine--top rear
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions