...engine is a 318 have a problem with the charging system have replaced the computer had the battery,alternator checked out o.k. getting fault code:1-2-40-1-5-5 what does this mean since there are no ...
...a defective ignition switch. A test/temporary workaround is to wire the ignition B+12 in the engine direct to the battery's + terminal and and try again. In some instances, it could be fusible ...
Question about 1993 B Series Cargo
...be the fuel filter if not replaced could be clogged up. if your getting good fuel pressure to the engine could need a tuneup. if your not getting power to the pump and it plugged in check the
...seconds. If not then you need to check if the relay is good, should be in the power box next to the engine. The second most common thing is lack of spark you can test it manually with a loose ...
...the passenger side near the alternator). Pull off the spark wire on top and have someone crank the engine to see if it 'sparks' to the mounting bracket. If it does, then look at fuel. If it doesn't, ...
...it. You can install a kit from your alt rebuilder to put an early regulator on it. But your check engine light will come on, you won't have 1500+ in a ...
I need a wiring diagram for 1980 dodge 318 brougham rv ( F 30 series) engine wiring only Engine Wiring ? or Firing Wiring order ? Request firing wire order for an 360 v8 2bbl dodge 1975 engine
...IT STARTS TO BACK FIRE THROUGH INTAKE IF GIVEN GAS AND ACTS LIKE IT IS GETTING TO MUCH FUEL AND THE ENGINE WANTS TO DIE IF I GIVE IT MORE GAS WILL DIE AND STARTS UP AND DOES THE SAME THING. CHECKED ...
Question about 1991 B Series Cargo
...clamp on all wires one at a time and check if there is signal at all plug wires while cranking the engine to start. If the timing light flashes, I pull spark plugs. sometimes one, sometimes more; ...
Usually answered in minutes!
16 Questions
7 Questions
10 Questions
9 Questions
5 Questions