Questions & Answers for: Chrysler LHS engine wiring

...wiring. So this remote switch should work. My LHS would stall and not start until I reset the PCM. The third mechanic I tried found the problem to be the camshaft position sensor. This sensor will ...

...fallow the possitive cable down you will see the starter on the driver side of the car, under the engine where the transmission and engine meet. you'll know it by the large, red wire running to

99'concorde stalls,wont start until cool again.. my 99'chrysler concorde stalls when the engine temprature reaches its normal heat level.it wont start until cool again..???my car has a new ...

2001 Chrysler LHS engine misfire Car shakes due to misfire. Engine runs but shakes when driving at over 40mph You have a spark plug or wire breaking down under pressure.I would have them changed.

flashing check engine light - spark coming from small module box on top of engine - spark plug wires run into that box - engine running rough - any help would be appreciated - Jack ALL SIGNS POINT TO ...

...plug wires and now it wont start? i checked for spark off the distributer all 6 were good? if your engine run before you changed anything,and you are talking about a 3.0 engine, you have to be ...

REPLACED PLUGS AND WIRES CAR WONT START? CHECKED FOR SPARK OFF THE DISTRIBUTER AND ALL 6 WERE GOOD TO GO, NOT SURE WHAT HAPPENED. IT STARTED WHEN I DROVE IT IN GARAGE BUT WOULDNT START AFER NEW PARTS.

...engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good ...

my 96 chrysler lhs has a knocking/rattleing sound coming from the bottom engine and as you push down on the gas the faster you drive the louder it rattles if the noise is coming from the bottom end of

where is the camshaft sensor located on a 1999 chrysler lhs 3.5 l engine Its on the left side of the engine on the cam cover right on top it has a three wire connector