Questions & Answers for: Chevrolet Malibu engine wiring

...engine and firewall. i did replace my plugs, there is a plastic clip on the alternator that holds the wiring on you can pop off to get out of the way to get to the plugs. Use gloves and if you have a ...

Ad

...cables 2003 Chevrolet Malibu 3.1L SFI OHV 6cyl Spark Plug Wires - Removal & Installation 3.5L Engine Before servicing the vehicle, refer to the Precautions Section. NOTE Twist the spark plug ...

Ad

check engine light flashes spitts and sputters has low power wont get over 45 mph Engine is misfiring, common causes are spark plugs and spark plug wires, could also be a coil, but plugs and wires are

Question about 2004 Malibu

1 Answer

...engine light came on. No history of this happening before. I took the car to get a diagnosis which read p0113. 1. check connector and wiring 2. sensor open or shorted replace sensor. I purchased the ...

...engine wiring harness aside. Position the starter to enable access to the solenoid wiring, then detach the wiring. Remove the starter from the vehicle. To install: Raise the starter to the vehicle, ...

Question about 2003 Malibu

1 Answer

...it goes and I have a 2inch by 2inch box with an i loop and dont know where it goes. I changed the engine and all went fine till i got to these two wires One of those wires should go to your engine ...

Question about 2000 Malibu

1 Answer

engine wiring diagram 2000 malibu i need to put my wiring to the engine on after i replaced the head gasket to my 2000 malibu plug it all in were it was chief

Question about 2007 Malibu

1 Answer

...engine wiring im doing a v6 swap DO YOU HAVE EVERYTHING FOR THE SWAP YOU NEED THE ENGINE THE WIRING HARNESS FROM THE DONOR AND THE COMPUTER/PCM WILL THE PRESENT TRANSMISSION WORK WITH THE NEW MOTOR ...

Question about 2003 Malibu

1 Answer

engine mechanical fault ( head gasket , cracked head , bent/burnt valves) ---wiring (HT lead, distributor cap or individual coil)--ignition / fuel ( injector and wiring)ECT/MAF sensor---ECM Go for the

wiring on the positive side touches any metal during this entire procedure.Disconnect the positive wire after each test to avoid any accidents. compression and timing are the only things left. Has any

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...