Questions & Answers for: Daihatsu Charade engine timing

timing plate above. Diagram here For a test try blocking the hose coming from the oil cap to the bottom of the carby. The cap is also a PCV valve and if it's not clean it can allow excess air into the

...timing should be 3-7°BTDC at 750-850 RPM with the engine check connector terminal 11 (brown) shorted, Fig. 1. The engine check connector is located near the top of the transaxle. here is the ...

engine timing how do I catch the timing on the engine are you trying to time the engine with the distributor? if so find the crankshaft pulley and look for the top dead center mark and mark it with ...

...engine backfired and stopped wont restart suspect valve timing has slipped although belt appears ok but loose. ignition timing is ok need to know how to align cam with crank for correct valve timing ...

...engine ... Hi Cas, 1) timing belt - see the small dot on tooted crank (small) pulley and match this with a notch ^ on engine body. Align the 'F' on overhead camshaft front pulley with lower crank ...

diagram motor injection timing daihatsu diesel 374 engine hoe to set timing injector dihatsu chared G101 non tourbo engin

...is performed. Ignition timing at 1000 RPM or less should be as follows: on 1989 1.3L/4-79 engines, 3-7°BTDC; on 1990-92 1.3L/4-79 engines, 0-2°; on 1.6L/4-97 engines,

...timing belt replacement and what are the belt change intervals? Is this an interfearance engine? Many thanks. Nigel. Usually belt change int. is 60-70,000 miles. And its not that easy to change..and ...

...Engine At A Normal Consistent RPM for about 30 Sec To Bring Every Thing To Normal....... After That No Issue With The Car............... Self Is Checked and Car Timing Has Been Reset To Normal Kindly ...

...timing belt has snapped on my diahatsu charade 91 model. will the engine need to be replaced now? Eg; is it a free spinning engine? i seem to think its a free spinning engine as you so elequently put ...