Questions & Answers for: Chevrolet C1500 engine timing

Question about 1988 C1500

1 Answer

...timing codes for 88 chevy c1500 2wd 4.3l v6 no ac . my engine knocks and struggles to run when idle ive tried everything else.please help Have you tried to replace the IAC (idle air control) valve? ...

Ad

...engine with a timing lilght what are the steps to time a 1994 chev truck with a 350 engine with a timing light? engine idle and then check strobe light to mark on crank ,then slowly rev engine to ...

Ad

...engine at base timing .. use timing light to see timing and turn the distributor after its loostened if nescessary to adjust it then retughten and turn off engine then reconnect the spout connector ...

...way to check engine timing and what should it be set at. what should I change next? try timing i set mine at 4 degrees btc,dont forget to unhook your distributor bypass located behind your ...

Question about 1990 C1500

1 Answer

engine the timing will advance for second or two and then returns to static. This happens when I rev up and stay at steady rpm. I have tried disconnecting the knock sensor but all this does is put the

Question about 1997 C1500

1 Answer

...engine code p1345 camshaft to crankshaft position correlation fault. I dont know what this means. Most likely the timing has jumped,or the cam sensor is bad. you need to get your distributor timing ...

block? and what is the firing order on the same motor? 1-8-4-3-6-5-7-2 The timing depends on which horspower engine you have. The 502 hp engine is 12 degrees, I don't know about any of the other 502's

...engine to get to the timing cover. Loosen the oil pan bolts to allow the timing cover to be slipped out. unbolt and remove the timing cover. Turn the engine over by hand until the dot on the ...

...engine over again until the timing marks align and the rotor should be pointing towards the firewall as described above. Find the closest terminal in the distributor cap that matches the rotor's ...

Question about 1988 C1500

2 Answers

timing the engine was loose. I repared the connection and the idle improved and the light went off. After driving the truck 5 miles or so approching a stop light in 5th gear under no accelerration the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...