...Engine the thermostat and the neck where the hose goes on is one unit $25 at autozone Remove the necessary coolant from the radiator. Remove the alternator, Loosen the outlet hose clamp at the ...
...follow upper rad hose to the engine, where hose hooks up is the thermostat housing. remove the bolts and thermo is
...engine Install the thermostat housing to the engine block. Install the thermostat housing bolts and tighten to 89 inch lbs. (10 Nm). Lubricate the inner diameter of the radiator hose with engine ...
need to remove it. Just unscrew bolt on thermostat housing ( follow upper radiator hose to engine) remove housing and thermostat, and replace, make sure spring side of thermostat goes inside of engine
...engine. THERMOSTAT REPLACEMENT (5.3L ENGINE) 1. Drain Radiator and remove the radiator outlet hose. 2. Remove the water pump inlet bolts. 3. Remove the water pump inlet and thermostat from the water ...
...engine coolant level * Leaking or stuck open thermostat * Faulty cooling fan (running too much) * Faulty coolant temperature (ECT) sensor * Faulty intake air temperature (IAT) sensor Possible ...
Clean all of the surfaces of the thermostat housing. Clean the sealing surface of the engine block.Thanks The thermostat and housing are made as one complete unit. You can't remove it from the housing
...thermostat or sensor, for engine runing too cool. In all probability the thermostat stopped working, and it is not blocking the flow of fresh water from radiator. The only way i can think a sensor ...
...Engine The thermostat is located between the water outlet and a housing built into the intake manifold. CAUTIONNever open, service or drain the radiator or cooling system when hot; serious burns can ...
...side of the engine, below & behind the alternator. If you have a V8 cylinder engine is in front of engine see the picture. Item 303 thermostat housing, 305 thermostat, and 304 thermostat
Usually answered in minutes!
2,225 Questions
1,368 Questions
1,418 Questions
593 Questions
540 Questions