...into cylinder head with jiggle pin positioned up.) 6. Place thermostat housing 7. Fill radiator with engine coolant 8. Connect battery negative cable 9. Start engine and check for leaks. Good ...
thermostat-1.5L engine shown, 1.8L similar Fig. Exploded view of the thermostat-1.6L engine Fig. Water inlet fitting (A) and thermostat-2.0L engine To install: Place the thermostat in the housing with
Sorry ! I'd check and clean all the grounds in the engine compartment. check the thermostat. make sure you don't have a coolant leak the sensor reads when it is immersed in coolant it won't read steam
...thermostat housing located on this engine? Follow your Top radiator hose all the way top the engine IN that aluminum area is your thermostat OPen clamp on hose Coolant will run a little off the top ...
...engine and thermostat housing using the gasket scraper. Then install a replacement thermostat in the housing, with the thermostat orienting the same way as the original. Then install the gasket and ...
...engine and thermostat housing using the gasket scraper. Then install a replacement thermostat in the housing, with the thermostat orienting the same way as the original. Then install the gasket and ...
Question about 2010 Soul 2.0
...Engine overheats if the thermostat is stuck in the closed position. Engine can be damaged permanently. Engine takes a long time to heat up if the thermostat is stuck in the open position. Defective ...
Question about 2010 Soul 2.0
...engine block. The thermostat is housed (recessed) in the engine block itself at the base of the angled pipe to which the radiator hose is attached. You will need to drain the coolant and remove the ...
...engine by three bolts. This is the thermostat housing, and the thermostat is inside. How to Remove It Drain the coolant from the radiator to minimize coolant spills. Remove the three nuts from the ...
Usually answered in minutes!
1,074 Questions
1,065 Questions
1,058 Questions
1,036 Questions
974 Questions