Questions & Answers for: Mazda 626 engine no start

...start the engine. The voltage of 12V which must be on the alternator when the contact is ON is not there. The fuses are ok. Probably there is a relay between, which stops the voltage to be on ...

...postive side of the battery for 5mints.. this should clear any codes..hook battery back up..start engine if engine runs first time..you got a something in your ingction system that not working

...start the engine, run until it stops, then crank several times to relieve residual pressure)" The engine compartment fuse block has several relays, none of them labeled "fuel pump relay." I guessed ...

engine not starting after I had an engine owerheated problem I was driving when suddendly a hose joining the radiator and the engine exposed. The engine started overheating. I stop the car and pour ...

...engine would not start, I moved gear lever a few times and engine started fine, most probably the throttle body is whats causing it to stop. first try removing it and clean it thoroughly with any ...

...engine 626 won't start. Got into vehicle. Started engine. Engine stalled when accelarated. Had to have vehicle towed home. Check of EGR valve showed rusted out. Replaced EGR valve. Started engine, ...

...start and the engine light was still on. what else should i do next. sometimes when you run out of gas your fuel pump is dry ,you need to put lots of gas in then turn your key to the on position with ...

...engine light on. It will start, but when put into any gear will die. It can be low fuel pressure issue or clogged fuel pump. Or its engine related issues,--------------- Check the help link mentioned ...

...start. The engine is making a drumming noise and the car is turning over but it's have a problem catching and starting the engine like it should. It's been sitting in my driveway for two months since ...

...engine does not start, and start only when I open the TP sensor.After that when engine temperature reach to 80 C,the engine is starting.But idle was around 400 r/min your Tp sensor is faulty it needs ...