Questions & Answers for: engine stalls

...engine stalls. shift to nuetral, wait for engine rotation to stop. restart and shift back to drive. engine runs normally for 1/2 to 2 miles then stalls again. When engine stalls there is a minor ...

engine stalls Hi, car stalling problem often means the engine is not getting enough fuel and/or too much air. A cold engine needs a fairly rich fuel mixture to start, and to idle smoothly while it ...

...Engine stalls when gas is given? http://technoanswers.blogspot.in/2012/01/engine-stalls-when-gas-is-given.html------------1990 mazda 323 stalls and quit running? ...

...Engine stalls when gas is given? http://technoanswers.blogspot.in/2012/01/engine-stalls-when-gas-is-given.html ------------- Car stalls when MAF sensor is connected? ...

...Engine stalls when gas is given? http://technoanswers.blogspot.in/2012/01/engine-stalls-when-gas-is-given.html ------------- Car stalls when MAF sensor is connected? ...

...engine stalls when put in any gear All fluids have been checked and fine. No service engine or check engine light on. It will start, but when put into any gear will die. It can be low fuel pressure ...

stalls are complex. over 50 ways to stall any gas engine. first is not doing a tuneup. then. 1: lost 12vdc power to EFI system (dash goes dead) 2: lost engine compression 3: lost spark 4: bad fueling.

stalls, engine lite on, why? all stalls end in CEL check engine light on. that is normal but CEL glow. when engine running , means you had a failure, and it stored DTC error codes, so scan it. lots of

...engine stalls. the RPM drops to 0 the EFI sees that and goes to key on, not started self test. this is covered in the operator guide. key light comes on KEY LIGHT, HUMMMMMMM Let me look at the waring ...

stalls is a weak engine. or IAC idle controls are dead. if you shift to D fast, will the engine stall (Die)? if engine goes below 800 RPM that is IAC failure, in any gear. but if you are savvy and hot