Questions & Answers for: kawasaki engine overheat high speed

...High Altitude & on a "moist day" without Pillion Passenger ,& with Engine having Air Cleaners near new,& providing each Cylinder registered similar Compression Pressure , Perhaps 15 Psi & The Engine ...

Ad

Question about 1987 GPz 1000 RX

2 Answers

...high revs would indicate that all the fuel and air it needs are getting to the engine and you also have a good spark. Probably no problem with air and fuel filter ( if fitted) or sparkplugs. Running ...

Ad

...engine is hot,radiator looses coolant to header bottle, The coolant does not return when it cools and eventually overheats well you either have a blown head gasket or a cracked liner also a blown ...

high speed misfire on a 1988 kawasaki vulcan 1500 engine runs fine at idle and midrange.full throttle no problem at lower engine speeds.this bike does'nt have a tach,so i can't say exactly what rpm ...

...high at speeds over 55mph. If the bike is reving high in top gear but you are not gaining speed or very little speed your clutch is slipping. This is a sign the clutch needs replaced. clutch ...

Question about 2001 ZX-12R

0 Answer

...high rpm.all sensors are hooked up and no engine malfunction lites .Power balance and exhaust gas temps are even.Fuel hoses are installed correct with pressure side hooked on throttle side opp. fuel ...

Question about Full Suspension Mountain Bike Men

1 Answer

high speed mixture problem. Is your ski spitting water out the tiny hole on the side? You should try flushing the engine, you could have a motor full of sand if you beach the craft but do not wash the

Question about Fh641v 21hp 21 Hp Riding Lawn Mower Engine ()

1 Answer

high speed only under a load. what can i do to fix it? This sounds like you have a partially clogged idle jet in the carburetor. You can get a rebuild kit from a shop like www.arcolaw for a fair price

Question about 1998 VN 800 Vulcan Classic

1 Answer

...engine to overheat. 18 Check the engine oil levels by removing the cap and dipstick from the oil filler, located on the bottom left side of the Vulcan 800. Dry the dipstick with a shop rag, return it ...

Question about 2008 Mule 3010 Trans 4x4

1 Answer

...high speeds 2002 3010 mule rear wheels are locking up at top speeds, when you shut the engine off and restart it drives normally at low speeds until you get going faster then the rear wheels lock up ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...