Questions & Answers for: engine 12v

Question about 1993 240SX

1 Answer

...ENGINE IDLES UP, THE AUXILLARY FAN COMES ON, BUT THE COMPRESSOR CLUTCH DOES NOT ENGAGE. COMPRESSOR IS NEW.I ALREADY CHECK FUSES & RELAYS.COULD IT BE THE THE CYCLING SWITCH?. HI, Yeah have the voltage ...

Ad

Question about 1992 XJ6

1 Answer

...engine runs fine. Could this be a bad connection beteen the batery and relay? Ignition off - no current draw - 12v, but with the ignition on and the pump providing a load the whole 12v is dropped ...

Ad

...on canister and the ''service engine soon'' lite goes out. Shouldn't 12v from anywhere trigger the relay? the ground comes from the ecm. either the ground wire is open or ecm is not sending the ...

Question about 1998 Taurus

1 Answer

...1998 ford taurus. Which engines are interchangeable with a 1998 ford taurus. Can a 1996 engine for a ford taurus be used? you should be able to. as long as you swap a 12v with a 12v or 24v with a ...

...12v is only supposed to work when your engine alternator is running as this as you have stated is a big drain in the 12v system. It will only normally switch on when your ignition light has gone out ...

Question about 1996 Golf

1 Answer

...ENGINE AND PUMP RELAYS OK NEW HALL SENDER IN DISSY, NEW CRANK SENDER, AND COIL UNIT.NO FAULTS SHOWING ON DIAGNOSTICS.ANY SUGGESTIONS. check for 12v at injector plug if no 12v this is fed from the ecu ...

...12V and if the engine did run, the voltage should stay at +12V. The Ford manual states +12v should be at the motor for some number of seconds in the key "on" position then drop off if the engine is ...

...pins. You must connect the ACC pin to +12V as well. The +12V is the permanent connection and the ACC is for the +12V that becomes energised when you turn the ignition on and have the engine

...tried to operate 12v mode. From the user manual it needs the fridge cooled down on gas or mains first and it will only operate at 12V if the engine is running to prevent vehicle battery running

Engine, ABS diagnostic for all models produced until 2000's A. +7.35v permanently and +12V when ignition is on. B. Empty F. +12V permanently G. Empty H. Empty J. Empty L. +12V when ignition is on. M.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...